Too Many Flash Options Installed; Too Many Trays Attached; Remove Defective Disk - Lexmark X548 Series User Manual

57 Configuration change, some held jobs were not restored
Something has changed in the printer to invalidate the held jobs. Possible changes include:
• The printer firmware has been updated.
• Paper input options needed for the print job were removed.
• The print job was created using data from a device in the USB port and the device is no longer in the USB port.
•
The printer hard disk contains print jobs that were stored while installed in a different printer model.
Touch Continue to clear the message.

58 Too many flash options installed

1
Turn the printer off.
2
Unplug the power cord from the wall outlet.
3
Remove the excess flash memory.
4
Connect the power cord to a properly grounded outlet.
5
Turn the printer back on.

58 Too many trays attached

1
Turn the printer off.
2
Unplug the power cord from the wall outlet.
3
Remove the additional trays.
4
Connect the power cord to a properly grounded outlet.
5
Turn the printer back on.
59 Incompatible tray [x]
Try one or more of the following:
• Remove the specified tray.
• Touch Continue to clear the message and continue printing without using the specified tray.

61 Remove defective disk

Try one or more of the following:
•
Touch Continue to clear the message and continue printing.
•
Install a different printer hard disk before performing any operations that require a printer hard disk.
Troubleshooting
249