Miscellaneous Security Settings Menu - Lexmark X548 Series User Manual

Miscellaneous Security Settings menu

Menu item
Login Restrictions
Login failures
Failure time frame
Lockout time
Panel Login Timeout
Remote Login Timeout
Security Reset Jumper
Access controls = "No Security"
Reset factory security defaults
No Effect
LDAP Certificate Verification
Demand
Try
Allow
Never
Minimum PIN Length
1-16
Description
Limits the number and time frames of failed login attempts from the printer control
panel before all users are locked out
Notes:
•
"Login failures" specifies the number of failed login attempts before users are
locked out. Settings range from 1–10. 3 attempts is the factory default setting.
•
"Failure time frame" specifies the time frame during which failed login attempts
can be made before users are locked out. Settings range from 1–60 minutes. 5
minutes is the factory default setting.
• "Lockout time" specifies how long users are locked out after exceeding the login
failures limit. Settings range from 1–60 minutes. 5 minutes is the factory default
setting.
•
Panel Login Timeout specifies how long the printer remains idle on the home
screen before automatically logging the user off. Settings range from 1–900
seconds. 30 seconds is the factory default setting.
• Remote Login Timeout specifies how long a remote interface remains idle before
automatically logging the user off. Settings range from 1–120 seconds. 10
minutes is the factory default setting.
Changes the value of the security settings
Notes:
•
Access controls = "No Security" is the factory default setting. It retains all the
security information that the user has defined.
• "Reset factory security defaults" deletes all security information that the user
has defined, and assigns the factory default value to each setting in the
Miscellaneous Security Settings section of both the printer control panel and the
Web page.
•
No Effect means the reset has no effect on the device security configuration.
Allows the user to request a server certificate
Notes:
•
Demand is the factory default setting. This means a server certificate is
requested. If a bad certificate is provided or if no certificate is provided, the
session is terminated immediately.
•
Try means a server certificate is requested. If no certificate is provided, the
session proceeds normally. If a bad certificate is provided, the session is
terminated immediately.
•
Allow means a server certificate is requested. If no certificate is provided, the
session proceeds normally. If a bad certificate is provided, it will be ignored and
the session proceeds normally.
• Never means no server certificate is requested.
Limits the digit length of the PIN
Note: 4 is the is the factory default setting.
Understanding printer menus
146