Step 7
While holding the new COLUMN in one hand, feed the WIRE HARNESS through the tube as shown with your other
hand. continue feeding the WIRE until the CONNECTOR at the end of the WIRE HARNESS pushes out through the
opening at the other end of the new COLUMN.
Step 8
While still holding the new COLUMN in one hand, pull the CONNECTOR up and out of the tube, taking the slack out
of the WIRE. Set the new COLUMN, angled towards the user, on top of the FRAME. Align the holes in the lower
end of the new COLUMN with those in the FRAME. Install the (4) SCREWS which secure the new COLUMN to the
FRAME with a 7/32" hex key wrench.
Step 9
Reverse steps 1 through 8 to return all parts back into place.
8