Power Button/Led Board - HP ProLiant BL40p Maintenance And Service Manual

Power Button/LED Board

To remove the power button/LED board:
1. Power down the server blade and remove it from the server blade enclosure. Refer to the
"Server Blad e Preparation" section in this chapter.
2. Remove the access panel and the system board tray assembly. Refer to the "Server Blade
Preparation" section in this chapter.
3. Use a Torx-15 screwdriver to remove the two retaining screws from the power
button/LED board (1).
4. Lift the power button/LED board off the chassis (2).
Figure 2-35: Removing the power button/LED board
Reverse steps 1 through 4 to replace the power button/LED board.
HP ProLiant BL40p Server Blade Maintenance and Service Guide
Removal and Replacement Procedures
2-35