Fujitsu SPARC Enterprise M3000 Xscf Reference Manual page 164

restoredefaults(8)
150 SPARC Enterprise Mx000 Servers XSCF Reference Manual • Last Revised January 2012
Restores the server.
EXAMPLE 2
XSCF> restoredefaults -c factory
WARNING:
If this system does not have OPNL, this command will set all the user
settable XSCF configuration parameters to their default value as they
were set when the system was shipped out.
Furthemore, this command will delete all logs on both XSCFUs.
Check the man page of this command before you run it.
Continue?[yes/no](default no):yes
You must check the following points.
1. Have the ability to powercycle the system.
2. Have access to the serial console and hold the serial console of the
XSCFU to confirm the completion of the command.
If you answer "yes" this command will HALT the XSCFU when it completes.
You will need to powercycle the system after the XSCF BOOT STOP.
Do you really want to continue?
Continue?[yes/no](default no):yes
The initialization of XSCFU will be started.
XSCFU : all data clear
OPNL : all data clear (exclude SYSTEM ID data)
XSCF will be automatically rebooted. Afterwards, XSCFU will be
initialized.
Continue?[yes/no](default no):yes
The NVRAM setting of XSCFU#0 was completed.
XSCF shutdown request was completed.
<snip>....XSCF reboot..<snip>
***** WARNING *****
XSCF initialization terminate for XSCF/OPNL data clear.
execute "setdefaults factory" (AUTO)
setdefaults : FACTORY mode clear : start
setdefaults : FACTORY mode clear : DBS start
setdefaults : FACTORY mode clear : wait 20s for DBS initialization
initialize OPNL SEEPROM 1/6
...
initialize OPNL SEEPROM 6/6
setdefaults : FACTORY mode clear : OPNL reset complete
setdefaults : FACTORY mode clear : restore SYSTEM-ID data complete
-- complete
-- complete