ZyXEL Communications ZyWALL USG 300 User Manual page 1007

Table 303 Interface Logs (continued)
LOG MESSAGE
System default ppp
interface can not be
removed.
Interface property can
not change to internal
since interface is the
member of other trunk.
Port-grouping is not
support
This interface type
can not set 3rd-dns.
name=%s,status=%s,TxP
kts=%u,
RxPkts=%u,Colli.=%u,T
xB/s=%u,
RxB/s=%u,UpTime=%s
Interface %s has been
renamed from '%s' to
'%s '
Table 304 WLAN Logs
LOG MESSAGE
Wlan %s is enabled.
Wlan %s is disabled.
Wlan %s has been
configured.
Interface %s has been
configured.
Interface %s has been
deleted.
Create interface %s
has failed. Wlan
device does not exist.
System internal error.
No 802.1X or WPA
enabled!
System internal error.
Error configuring WPA
state!
ZyWALL USG 300 User's Guide
DESCRIPTION
A PPP interface could not be removed because it is a system
default PPP interface.
An interface can not be set to be an internal interface because
it is a member of a trunk.
The interface does not support port grouping.
This type of interface does not support setting a third DNS
server setting.
This log is sent to the VRPT server to show the specified PPP/
Cellular interface's statistics and uptime.
The arguments represent the interface name, interface
status, interface Tx packets, interface Rx packets, interface
collision packets, interface Tx Bytes/s, interface Rx Bytes/s,
and interface up time.
The user-configurable name of the specified interface
(internal system name) has been renamed from one name to
another.
DESCRIPTION
The WLAN (IEEE 802.11 b and or g) feature has been turned
on. %s is the slot number where the WLAN card is or can be
installed.
The WLAN (IEEE 802.11 b and or g) feature has been turned
off. %s is the slot number where the WLAN card is or can be
installed.
The WLAN (IEEE 802.11 b and or g) feature's configuration
has been changed. %s is the slot number where the WLAN
card is or can be installed.
The configuration of the specified WLAN interface (%s) has
been changed.
The specified WLAN interface (%s) has been removed.
The wireless device failed to create the specified WLAN
interface (%s). Remove the wireless device and reinstall it.
IEEE 802.1x or WPA is not enabled.
The ZyWALL was not able to configure the wireless device to
use WPA. Remove the wireless device and reinstall it.
Appendix A Log Descriptions
1007