Exterior Lighting; Automatic Headlamp Mode; Low-Beam Headlamps - Mercedes-Benz CL Operator's Manual

Turn the light switch to $ or c.
X
or
If the rear fog lamp is switched on: press
X
the light switch in to the stop.

Low-beam headlamps

To switch on the low-beam headlamps:
X
turn the SmartKey in the ignition lock to
position 2 or start the engine.
Turn the light switch to L.
X
The T indicator lamp on the light switch
lights up.
To switch off the low-beam
X
headlamps: turn the light switch to $.
Daytime running lamps
Daytime running lamps in Canada
The daytime running lamps function is
required by law in Canada. It cannot therefore
be deactivated.
Turn the light switch to $ or c.
X
With the engine running: depending on the
ambient light, the daytime running lamps or
the low-beam headlamps are switched on.
When the low-beam headlamps are
switched on, the T indicator lamp on
the light switch lights up.
When the engine is running and the vehicle is
stationary or if the electronic parking brake is
applied: if you move the selector lever from a
drive position to P, the daytime running
lamps/low-beam headlamps go out after
three minutes.
When the engine is running, the vehicle is
stationary and in high ambient light
brightness: if you turn the light switch
to T, you turn on the daytime running
lamps and parking lamps.
If the engine is running and you turn the light
switch to L, the manual settings take
precedence over the daytime running lamps.
Only if daytime running lamps have been activated via the on-board computer.
10
Daytime running lamps in the USA
In the USA, the daytime running lamps are
deactivated upon delivery from the factory.
To activate the daytime running
X
lamps: activate the daytime running lamps
function in the on-board computer
( page 349).
Y
Turn the light switch to $ or c.
X
With the engine running: depending on the
ambient light, the daytime running lamps or
the low-beam headlamps are switched on.
When the low-beam headlamps are
switched on, the T indicator lamp on
the light switch lights up.
If the engine is running and you turn the light
switch to T or L, the manual settings
take precedence over the daytime running
lamps.

Automatic headlamp mode

To switch on automatic headlamp
X
mode: turn the light switch to c.
SmartKey in position 1 in the ignition lock:
the parking lamps are switched on or off
automatically depending on the brightness
of the ambient light.
With the engine running: depending on the
brightness of the ambient light, the daytime
10
running lamps or the parking lamps and
low-beam headlamps are switched on or off
automatically.
When the low-beam headlamps are
switched on, the T indicator lamp on
the light switch lights up.
G WARNING
If the light switch is set to c, the low-beam
headlamps will not come on automatically if
it is foggy. This could endanger you and
others. Therefore, turn the light switch to
L in fog.

Exterior lighting

Z
251