Mercedes-Benz CL Operator's Manual page 180

Navigation
178
Map software is not compatible with the
current system software
You will see a message that the system
software and the map software are not
compatible.
To confirm the message: press W.
X
COMAND ejects the DVD.
Take the DVD out of the slot.
X
Have the system software updated at an
X
authorized Mercedes-Benz Center.
The map software cannot be installed until
the system software has been updated.
Map software compatible with the
navigation system and the current
system software
COMAND checks whether the map data on
the DVD is already installed.
Map data is already installed
You will see a message that the map data is
already installed. A prompt will also appear
asking you whether you wish to continue with
the map software installation.
Select Yes or No.
X
If you select Yes, the existing map data is
overwritten.
If you select No, COMAND automatically
ejects the DVD and the installation of the
map software is canceled.
Take the DVD out of the slot.
X
Map data is not installed yet
In the display, you will see a comparison of
the version statuses of the map software DVD
and the map software installed in COMAND.
A prompt then appears asking whether the
map software installation should be carried
out.
Select Yes or No.
X
If you select Yes, the map data is installed.
If you select No, COMAND automatically
ejects the DVD and the installation of the
map software is canceled.
Take the DVD out of the slot.
X
If an activation code is required for the map
software, a prompt appears in the display
requesting the code to be entered.
Enter the activation code and confirm the
X
entry with !.
The map software is installed.
If you enter an incorrect activation code, the
prompt to enter the activation code appears
again. If the activation code is entered
incorrectly three times, the prompt asking
you to enter the activation code appears after
a time delay. The time delay increases every
time the activation code is entered
incorrectly, from five minutes up to a
maximum of five hours.
Installing map data
Just before the copying process starts,
COMAND restarts the system.
While the installation is running, you will see
a message to this effect and a progress bar.
To cancel the installation process: eject
X
the DVD.
Take the DVD out of the slot.
X
i
If you interrupt the installation process,
the navigation system will not be
operational. You can continue an
interrupted installation process at a later
date.
Installation process with multi-DVD
X
map data: once the content of the first
DVD has been installed, a message appears