Destinations; Selecting A Destination From The Destination Memory - Mercedes-Benz CL Operator's Manual

Navigation
146
Entering an intersection name
Entering an intersection will delete a
previously entered house number.
Select Intersection
X
address entry menu by turning cVd and
sliding ZVÆ the COMAND controller and
press W to confirm.
You will see the intersection list either with
the character bar (option 1) or as a
selection list (option 2).
Option 1: intersection list with character
bar
Enter an intersection. Instructions for
X
entering characters using city input as an
example can be found in the "Entering
characters in navigation mode (entering a
city)" section (
List entry most closely resembling the
:
characters entered so far
List
;
Character bar
=
Option 2: intersection list as selection list
(intersection) in the
page 122).
Y
Select an intersection by turning cVd the
X
COMAND controller.
Irrespective of the option, press W to
X
confirm your selection.
The address entry menu appears again. The
intersection selected has been entered.
Start route calculation (
X
Selecting a destination from the
destination memory (e.g. My address)
Introduction
The destination memory always contains an
entry named "My address". You may wish to
assign your home address to this entry, for
example ( page 144), and select it for route
Y
guidance. This entry is always located at the
top of the list in the destination memory.
To activate navigation mode: press the
X
S function button once or twice.
To show the menu: press W the COMAND
X
controller.
Select Destination
X
system menu bar by turning cVd the
COMAND controller and pressing W to
confirm.
Select From Memory
X
confirm.
Select My Address
X
COMAND controller.
Irrespective of the option, press W to
X
confirm your selection.
"My address" has been entered.
To start route calculation: select
X
and press W to confirm.
Entering a destination from the list of
last destinations
To activate navigation mode: press the
X
S function button once or twice.
page 143).
Y
in the navigation
and press W to
by turning cVd the
Start