Eq Tab; Kbd Tab - Roland Integra-7 Parameter Manual

Parameter
Legato Switch
Voice Reserve

EQ tab

EQ Switch
EQ Low Freq
EQ Low Gain
EQ Mid Freq
EQ Mid Gain
EQ Mid Q
EQ High Freq
EQ High Gain

KBD tab

Key Fade Upper
Key Range Upper
Key Range Lower
Key Fade Lower
Value
OFF, ON, TONE
0–63, FULL
OFF, ON
200, 400 [Hz]
-15–+15 [dB]
200, 250, 315, 400, 500, 630, 800,
1000, 1250, 1600, 2000, 2500, 3150,
4000, 5000, 6300,8000 [Hz]
-15–+15 [dB]
0 .5, 1 .0, 2 .0, 4 .0, 8 .0
2000, 4000, 8000 [Hz]
-15–+15 [dB]
Level
Fade Lower
Range Lower
0–127
LOWER–G9
C-1–UPPER
0–127
Explanation
You can add legato when performing monophonically . The term
in which notes are smoothly connected to create a flowing feel . This creates a smooth transition
between notes, which is effective when you wish to simulate the hammering-on and pulling-off
techniques used by a guitarist .
"ON"
Turn this parameter when you want to use the Legato feature and
you want to use the Legato Switch setting of the tone assigned to the part, set this to
* This is not shown in PART VIEW -ALL- .
SN-A SN-A SN-A
(Ac .Piano) (Organ) (Other)
ü –
This setting specifies the number of voices that will be reserved for each part when more than 128
voices are played simultaneously .
It is not possible for the settings of all parts to total an amount greater than 64 .
* This is not shown in PART VIEW -ALL- .
EQ for each part on/off setting
Frequency of the low range
* This is not shown in PART VIEW -ALL- .
Gain of the low frequency range
Frequency of the middle range
*
This is not shown in PART VIEW -ALL- .
Gain of the middle frequency range
Width of the middle frequency range
Set a higher value for Q to narrow the range to be affected .
*
This is not shown in PART VIEW -ALL- .
Frequency of the high range
*
This is not shown in PART VIEW -ALL- .
Gain of the high frequency range
Fade Upper
Range Upper
Determines what will happen to the Part's level when a note that's higher than its specified
keyboard range is played . Higher settings produce a more gradual change in volume .
If you don't want the Tone to sound at all when a note above the keyboard range is played, set this
parameter to 0 .
Specifies the highest note that the tone will sound for each part .
*
It is not possible to set Lower to a value greater than the Upper value, or Upper to a value less
than the Lower value .
Specifies the lowest note that the tone will sound for each part .
Determines what will happen to the Part's level when a note that's lower than its specified
keyboard range is played . Higher settings produce a more gradual change in volume .
If you don't want the Tone to sound at all when a note below the keyboard range is played, set this
parameter to 0 .
Studio Set –
"legato"
"OFF"
SN-S SN-D
– ü –
Pitch
EQ tab
refers to a playing style
when you don't . If
"TONE."
PCMS PCMD
ü –
7