Tva Tab - Roland Integra-7 Parameter Manual

PCM Synth Tone (PCMS) –
Parameter
TVF Env Time KF
TVF Env Time 1–4
TVF Env Level 0-4

TVA tab

Partial Level
Level V-Curve
Level V-Sens
Bias Level
Bias Position
Bias Direction
58
TVA tab
Value
-100–+100
0–127
0–127
0–127
FIXED, 1–7
-63–+63
-100–+100
C-1–G9
Selects the direction in which change will occur starting from the Bias Position .
LWR
UPR
L&U
ALL
Explanation
Use this setting if you want the TVF envelope times (Time 2–Time 4) to be affected by the keyboard
location . Based on the TVF envelope times for the C4 key (center C), positive
notes higher than C4 to have increasingly shorter times, and negative
to have increasingly longer times . Larger settings will produce greater change .
Time
C1 C2 C3 C4
Specify the TVF envelope times (Time 1–Time 4) . Higher settings will lengthen the time until the
next cutoff frequency level is reached . (For example, Time 2 is the time over which Level 1 will
change to Level 2 .)
* You can control this parameter using the Matrix Control .
T1 T2 T3
Cuto
Frequency
L0
L2 L3
L1
Note on
T: Time L: Level
Specify the TVF envelope levels (Level 0–Level 4) . These settings specify how the cutoff frequency
will change at each point, relative to the standard cutoff frequency (the cutoff frequency value
specified in the TVF screen) .
Sets the volume of the partial . This setting is useful primarily for adjusting the volume balance
between partials .
*
You can control this parameter using the Matrix Control .
You can select from seven curves that determine how keyboard playing strength will affect the
volume . If you do not want the volume of the partial to be affected by the force with which you
"FIXED."
play the key, set this to
1 2 3
Set this when you want the volume of the partial to change depending on the force with which
you press the keys . Set this to a positive
the more forcefully the keys are played; to make the partial play more softly as you play harder, set
"-"
this to a negative value .
MEMO
If you wish to make adjustments to the entire tone while maintaining the relative values of
TVA Level V-Sens among partials, adjust the Velocity Sens Offset parameter (p . 48) . However, this
setting is shared by the Cutoff V-Sens parameter (p . 57) .
Adjusts the angle of the volume change that will occur in the selected Bias Direction . Larger
settings will produce greater change .
Negative "-" values will invert the change direction .
Specifies the key relative to which the volume will be modified .
The volume will be modified for the keyboard area below the Bias Point .
The volume will be modified for the keyboard area above the Bias Point .
The volume will be modified symmetrically toward the left and right of the Bias Point .
The volume changes linearly with the bias point at the center .
"-"
settings will cause them
-100
-50
0
+50
+100
Key
C5 C6 C7
T4
Time
L4
Note o
4 5 6
"+" value to have the changes in partial volume increase
"+"
settings will cause
7