Gate; Delay - Roland Integra-7 Parameter Manual

MFX Parameters

33: Gate

Cuts the reverb's delay according to the volume of the sound
sent into the effect . Use this when you want to create an artificial-
sounding decrease in the reverb's decay .
L in
Gate
R in
Gate
Parameter Value
Threshold # 0–127
Mode GATE, DUCK
Attack
0–127
Hold
0–127
Release
0–127
D100:0W
Balance #
–D0:100W
Level 0–127
84
L out
R out
Explanation
Volume level at which the gate
begins to close
Type of gate
GATE: The gate will close when
the volume of the original sound
decreases, cutting the original
sound .
DUCK (Ducking): The gate will close
when the volume of the original
sound increases, cutting the original
sound .
Adjusts the time it takes for the gate
to fully open after being triggered .
Adjusts the time it takes for the
gate to start closing after the source
sound falls beneath the Threshold .
Adjusts the time it takes the gate to
fully close after the hold time .
Volume balance between the direct
sound (D) and the effect sound (W)
Output Level

34: Delay

This is a stereo delay .
When Feedback Mode is NORMAL:
Balance D
L in
Delay
Feedback
Feedback
Delay
R in
When Feedback Mode is CROSS:
Balance D
L in
Delay
Feedback
Feedback
Delay
R in
Parameter Value
Delay Left
0–1300 ms, note
Delay Right
Phase Left
NORMAL,
INVERSE
Phase Right
Feedback Mode NORMAL, CROSS
Feedback # -98–+98 %
200–8000
HF Damp
Hz, BYPASS
Low Gain
-15–+15 dB
High Gain -15–+15 dB
D100:0W
Balance #
–D0:100W
Level 0–127
2-Band
L out
EQ
Balance W
Balance W
2-Band
R out
EQ
Balance D
2-Band
L out
EQ
Balance W
Balance W
2-Band
R out
EQ
Balance D
Explanation
Adjusts the time until the delay
sound is heard .
Phase of the delay sound
Selects the way in which delay
sound is fed back into the effect .
(See the figures above .)
Adjusts the amount of the delay
sound that's fed back into the effect .
Negative "-" settings invert the
phase .
Adjusts the frequency above which
sound fed back to the effect is
filtered out . If you don't want to filter
out any high frequencies, set this
parameter to BYPASS .
Gain of the low frequency range
Gain of the high frequency range
Volume balance between the direct
sound (D) and the delay sound (W)
Output Level