About The Step Reset Function; Controlling A Mfx Via Midi (Mfx Control) - Roland Integra-7 Parameter Manual

About the STEP RESET function

04: Step Filter
18: Slicer
The above types contain a sixteen-step sequencer . For these types,
you can use a MFX CONTROL to reset the sequence to play from
the first step . To do this, set the MFX CONTROL Destination to
Reset."
For example if you are using the modulation lever to control the
effect, you would make the following settings .
Parameter Value
Source CC01: Modulation
Destination
Step Reset
Sens +63
With these settings, the sequence will play back from the first step
whenever you operate the modulation lever .

Controlling a MFX via MIDI (MFX CONTROL)

You can use MIDI messages such as control change messages to
control the principal MFX parameters . This capability is called
CONTROL (multi-effects control)."
The parameters that can be controlled are preset for each MFX type,
and are the parameters marked by a
"Step
explanations of each MFX parameter . Up to four multi-effects control
settings can be assigned using MFX 1–16 .
To use MFX CONTROL, you'll need to specify which MIDI message
(Source) will affect which parameter (Destination), and how greatly
(Sens) .
Parameter
Source (1–4)
Destination
(1–4)
Sens (1–4)
MFX Parameters
"#"
symbol in the following
Value Explanation
Specifies the MIDI message that will control the
corresponding MFX CONTROL parameter .
OFF MFX will not be used .
CC01–31 Controller number 1–31
CC33–95 Controller number 33–95
PITCH BEND Pitch bend
AFTERTOUCH Aftertouch
Use the controller that is assigned
SYS CTRL1–4 by the System Parameter setting
System Control 1–4 Source .
Selects the multi-effect parameter
that will be controlled by control
Refer to the
source 1–4 .
parameters
The type of parameters that can be
marked "#" on p .
selected will depend on the type
74 and following
of multi-effect you've selected in
MFX Type .
Specifies the depth of MFX
CONTROL .
Specify a positive
want to change the value of the
assigned destination in a positive
direction (larger, toward the right,
-63– +63
faster, etc .), or specify a negative
value "-" if you want to change
the value in a negative direction
(smaller, toward the left, slower, etc .) .
Larger values will allow a greater
amount of control .
"MFX
"+"
value if you
97