Roland Integra-7 Parameter Manual page 19

• Differences in your playing strength will smoothly change the tone character in a natural way .
•
A key-off noise typical of that instrument will be heard when you release the key .
Parameter
Noise Level (CC16)
Bell/Mallet
INT: 024 Glockenspiel
INT: 025 Vibraphone
INT: 026 Marimba
INT: 027 Xylophone
INT: 028 Tubular Bells
ExSN1: 001 Santoor
ExSN1: 002 Yang Chin
•
You can play a roll by operating the Modulation controller (CC01) while playing a note .
• You can produce a glissando effect by operating the pitch bend lever while holding down a note, or by playing legato with the Portamento SW (CC65)
turned on .
•
If Bend Range is set to Tone, you can produce a glissando effect by operating the pitch bend lever .
• If Bend Range is set to anything other than Tone, this effect will be obtained if Bend Mode (CC19) is turned on .
Use this when you want to switch between glissando playing and conventional pitch change .
• By using CC18, you can simulate the following technique .
INT: 024–028: the technique of using your hand or mallet to mute the vibration (sound) .
ExSN1: 001–002: the technique of playing a rapid and delicate roll (Slide Roll)
Parameter
Mallet Hardness (CC16)
Roll Speed (CC17)
Variation
Organ
INT: 029 TW Organ
• The sound will be unaffected by the strength with which you play the keyboard .
•
This allows you to use the nine harmonic bars to create your sound just as on a tone wheel organ .
Parameter
Harmonic Bar 16'
Harmonic Bar 5-1/3'
Harmonic Bar 8'
Harmonic Bar 4'
Harmonic Bar 2-2/3'
Harmonic Bar 2'
Harmonic Bar 1-3/5'
Harmonic Bar 1-1/3'
Harmonic Bar 1'
Leakage Level
Percussion Switch
Percussion Soft
Percussion Soft Level
Percussion Normal Level
Value
-64–+63
Value
-64–+63
-64–+63
Refer to p . 28 .
Value
0–8
0–8
0–8
0–8
0–8
0–8
0–8
0–8
0–8
0–127
OFF, ON
NORM, SOFT
0–15
0–15
SuperNATURAL Acoustic Tone (SN-A) –
Explanation
Adjusts the amount of hum noise and key-off noise . Higher settings will raise the volume .
Explanation
Adjusts the hardness of the mallet . Higher settings produce the sound of a harder mallet .
Adjusts the speed of the roll effect .
Performance variation sounds
Explanation
Adjust the level of each footage .
A different harmonic component is assigned to each footage; the sound of the organ is
created by mixing these components .
The 8' footage is the core of the sound; this is the basic pitch around which the sound is
created .
* Harmonic Bar 1' is unavailable if Percussion Switch is on .
Noise Level at which the signal of tone wheels unrelated to the pressed keys is mixed into
the input
If this is on, a crisp attack will be added to the beginning of the notes .
NORM: The percussion sound will be at the normal volume, and the sound of the harmonic
bars will be reduced .
SOFT: The percussion sound will be reduced, and the harmonic bars will be at the normal
volume .
Volume of the percussion sound when Percussion Soft is set to SOFT
Volume of the percussion sound when Percussion Soft is set to NORM
INST tab
19