Table of Contents
Advertisement
EQ/SEND Button
When you press the [EQ/SEND] button so it lights in red, you can control the 4-band EQ and Aux
send levels of the track/bus selected by CH SELECT.
PAN knobs 1–8:
PAN knobs 9–12:
EQ buttons 1-4:
PLUG-IN Button
When you press the [PLUG-IN] button so it lights in red, you can control DirectX 8 compatible
plug-in parameters for the track/bus selected by CH SELECT.
PAN knobs 1–10:
PAN knobs 11:
EQ button 1–4:
LOCATE Button
When you press the [LOCATE] button so it lights in red, the [Num Pad 1–0] buttons will have the
following functions.
[1]:
[2]:
[3]:
[4]:
[5]:
[6]:
[7]:
[8]:
[9]:
[0]:
EQ band #1–4 gain and freq. (Except MIDI track was selected.)
Aux 1-4 send level. (Only audio track was selected.)
EQ band #1–4 on/off
EQ are already assigned in the Cakewalk Normal template (Track 1-12). You need to
assign EQ manually, when using other tracks or templates.
Parameter 1-10 of plug-in selected by EQ buttons 1-4.
Bypass on/off of plug-in selected by EQ buttons 1-4.
Select plug-in 1-4.
The plug-in parameters to which the SI-24's knobs 1–10 correspond will depend on
the plug-in.
Specify the Now time as the time from which a selection extends.
Specify the Now time as the time through which a selection extends.
Set loop to selection.
Loop on/off.
Set the Now time to the end of the project.
Set the Now time to the From time.
Set the Now time to the Thru time.
Set the Now time to the previous marker.
Set the Now time to the next marker.
Insert a marker at the Now time (during playback) or a specified location.
Quick Start
23
Advertisement
Table of Contents
