Hexa-Chorus; Tremolo Chorus; Space-D; Overdrive - Roland Integra-7 Parameter Manual

MFX Parameters

25: Hexa-Chorus

Uses a six-phase chorus (six layers of chorused sound) to give
richness and spatial spread to the sound .
L in
Balance D
Hexa Chorus
R in
Balance D
Parameter Value
Pre Delay 0 .0–100 .0 ms
0 .05–10 .00 Hz,
Rate #
note
Depth 0–127
Pre Delay
0–20
Deviation
Depth Deviation -20–+20
Pan Deviation
0–20
D100:0W
Balance #
–D0:100W
Level
0–127

26: Tremolo Chorus

This is a chorus effect with added Tremolo (cyclic modulation of
volume) .
L in
Balance D
Tremolo Chorus
R in
Balance D
Parameter Value
Pre Delay 0 .0–100 .0 ms
0 .05–10 .00 Hz,
Chorus Rate #
note
Chorus Depth 0–127
0 .05–10 .00 Hz,
Tremolo Rate #
note
Tremolo
0–127
Separation
Tremolo Phase 0–180 deg
D100:0W
Balance #
–D0:100W
Level 0–127
82
L out
Balance W
Balance W
R out
Explanation
Adjusts the delay time from the
direct sound until the chorus sound
is heard .
Frequency of modulation
Depth of modulation
Adjusts the differences in Pre Delay
between each chorus sound .
Adjusts the difference in modulation
depth between each chorus sound .
Adjusts the difference in stereo
location between each chorus
sound .
0: All chorus sounds will be in the
center .
20: Each chorus sound will be
spaced at 60 degree intervals
relative to the center .
Volume balance between the direct
sound (D) and the chorus sound (W)
Output Level
L out
Balance W
Balance W
R out
Explanation
Adjusts the delay time from the
direct sound until the chorus sound
is heard .
Modulation frequency of the chorus
effect
Modulation depth of the chorus
effect
Modulation frequency of the
tremolo effect
Spread of the tremolo effect
Spread of the tremolo effect
Volume balance between the direct
sound (D) and the tremolo chorus
sound (W)
Output Level

27: Space-D

This is a multiple chorus that applies two-phase modulation in stereo .
It gives no impression of modulation, but produces a transparent
chorus effect .
Balance D
L in
Space D
Space D
R in
Balance D
Parameter Value
Pre Delay 0 .0–100 .0 ms
0 .05–10 .00 Hz,
Rate #
note
Depth
0–127
Phase 0–180 deg
Low Gain
-15–+15 dB
High Gain -15–+15 dB
D100:0W
Balance #
–D0:100W
Level 0–127

28: Overdrive

This is an overdrive that provides heavy distortion .
L in
Overdrive
R in
Parameter Value
Drive #
0–127
Tone #
0–127
Amp Sw OFF, ON
SMALL, BUILT-IN,
Amp Type
2-STACK, 3-STACK
Low Gain -15–+15 dB
High Gain -15–+15 dB
Pan # L64–63R
Level 0–127

29: Distortion

This is a distortion effect that provides heavy distortion . The
parameters are the same as for
L in
Distortion
R in
2-Band
EQ
Balance W
Balance W
2-Band
EQ
Explanation
Adjusts the delay time from the
direct sound until the chorus sound
is heard .
Frequency of modulation
Depth of modulation
Spatial spread of the sound
Gain of the low range
Gain of the high range
Volume balance between the direct
sound (D) and the chorus sound (W)
Output Level
Pan L
Amp 2-Band
Simulator EQ
Pan R
Explanation
Degree of distortion
Also changes the volume .
Sound quality of the Overdrive effect
Turns the Amp Simulator on/off .
Type of guitar amp
SMALL: small amp
BUILT-IN: single-unit type amp
2-STACK: large double stack amp
3-STACK: large triple stack amp
Gain of the low range
Gain of the high range
Stereo location of the output sound
Output Level
"28: Overdrive."
Pan L
Amp 2-Band
Simulator EQ
Pan R
L out
R out
L out
R out
L out
R out