Tvf Env Tab - Roland Integra-7 Parameter Manual

Parameter
Cutoff Keyfollow
Cutoff V-Curve
Cutoff V-Sens
Resonance V-Sens

TVF ENV tab

TVF Env Depth
TVF Env V-Curve
TVF Env V-Sens
TVF Env T1 V-Sens
TVF Env T4 V-Sens
Value
-200–+200
FIXED, 1–7
-63–+63
-63–+63
-63–+63
FIXED, 1–7
-63–+63
-63–+63
-63–+63
Explanation
Use this parameter if you want the cutoff frequency to change according to the key that is pressed .
Relative to the cutoff frequency at the C4 key (center C), positive
frequency to rise for notes higher than C4, and negative
to fall for notes higher than C4 .
Larger settings will produce greater change .
Cuto frequency
(Octave)
+2
+1
o
-1
-2
C1 C2 C3 C4
Selects one of the following seven curves that determine how keyboard playing dynamics
(velocity) influence the cutoff frequency . Set this to
to be affected by the keyboard velocity .
1 2 3
Use this parameter when changing the cutoff frequency to be applied as a result of changes in
playing velocity . If you want strongly played notes to raise the cutoff frequency, set this parameter
"+"
to positive settings . If you want strongly played notes to lower the cutoff frequency, use
"-"
negative settings .
MEMO
To edit the overall tone while preserving the relative differences in the Cutoff V-Sens values set
for each partial, set the Velocity Sens Offset parameter (p . 48) . However, this setting is shared by
the Level V-Sens parameter (p . 58) .
This allows keyboard velocity to modify the amount of Resonance . If you want strongly played
notes to have a greater Resonance effect, set this parameter to positive
strongly played notes to have less Resonance, use negative
Specifies the depth of the TVF envelope . Higher settings will cause the TVF envelope to produce
"-"
greater change . Negative settings will invert the shape of the envelope .
Selects one of the following 7 curves that will determine how keyboard playing dynamics will
"FIXED"
affect the TVF envelope . Set this to
the keyboard velocity .
1 2 3
Specifies how keyboard playing dynamics will affect the depth of the TVF envelope . Positive
"+"
settings will cause the TVF envelope to have a greater effect for strongly played notes, and
negative "-" settings will cause the effect to be less .
This allows keyboard dynamics to affect the Time 1 of the TVF envelope . If you want Time 1 to be
speeded up for strongly played notes, set this parameter to a positive
slowed down, set this to a negative "-"
The parameter to use when you want key release speed to control the Time 4 value of the TVF
envelope . If you want Time 4 to be speeded up for quickly released notes, set this parameter to a
positive "+" value . If you want it to be slowed down, set this to a negative
PCM Synth Tone (PCMS) –
"+"
settings will cause the cutoff
"-"
settings will cause the cutoff frequency
+200
+100
+50
0
-50
-200 -100
C5 C6 C7
Key
"FIXED"
if you don't want the Cutoff frequency
4 5 6
"+" settings . If you want
"-"
settings .
if you don't want the TVF Envelope to be affected by
4 5 6
"+" value . If you want it to be
value .
"-"
TVF ENV tab
7
7
value .
57