Wave Tab - Roland Integra-7 Parameter Manual

PCM Synth Tone (PCMS) –
Parameter
Portamento Time

WAVE tab

Partial Switch
Wave Group
Wave No .L (Mono)
Wave No .R
Wave Gain
Wave Tempo Sync
FXM Switch
FXM Color
FXM Depth
50
WAVE tab
Value
0–127
OFF, ON
INT,
SRX01–SRX12
(only if an expansion is loaded)
OFF, 1–
-6, 0, +6, +12 [dB]
OFF, ON
OFF, ON
1–4
0–16
Explanation
When portamento is used, this specifies the time over which the pitch will change . Higher settings
will cause the pitch change to the next note to take more time .
Used to specify whether partial 1–4 will be used (ON) or not used (OFF) .
Selects the group for the waveform that is to be the basis of the partial .
INT: Waveforms stored in internal
SRX01–SRX12: Expansion sound banks
Selects the basic waveform for a tone . Along with the Wave number, the Wave name appears at the
lower part of the display .
When in monaural mode, only the left side (L) is specified . When in stereo, the right side (R) is also
specified .
NOTE
If you specify only the right side (R), there will be no sound .
Sets the gain (amplification) of the waveform . The value changes in 6 dB (decibel) steps—an
increase of 6 dB doubles the waveform's gain . If you intend to use the Booster to distort the
waveform's sound, set this parameter to its maximum value (p . 53) .
When you wish to synchronize a Phrase Loop to the clock (tempo), set this to
This is valid only when an SRX waveform which indicates a tempo (BPM) is selected .
(Example: SRX05 3:080:BladeBtL, SRX08 5:75:BoomRvBel, etc .)
If a waveform from an SRX is selected for the partial, turning the Wave Tempo Sync parameter
"ON"
will cause pitch-related settings and FXM-related settings to be ignored .
When the Wave Tempo Sync is set to
With other settings, a delay effect will be applied, and you will be not be able to play as you expect .
Phrase Loop
"Phrase" loop refers to the repeated playback of a phrase that's been pulled out of a song (e .g ., by
using a sampler) . One technique involving the use of Phrase Loops is the excerpting of a Phrase
from a pre-existing song in a certain genre, for example dance music, and then creating a new
song with that Phrase used as the basic motif . This is referred to as
This sets whether FXM will be used (ON) or not (OFF) .
FXM
FXM (Frequency Cross Modulation) uses a specified waveform to apply frequency modulation to
the currently selected waveform, creating complex overtones . This is useful for creating dramatic
sounds or sound effects .
Specifies how FXM will perform frequency modulation .
Higher settings result in a grainier sound, while lower settings result in a more metallic sound .
Specifies the depth of the modulation produced by FXM .
*
You can use matrix control to modify this .
"ON,"
set the Partial Delay Time (p . 51) to
"Break Beats."
"ON."
"0."