Resetting Receiver To Factory Default Settings - Dish Network Receiver User Manual

Turning Caller ID On and Off
1. Press MENU on the Remote Control.
2. Select
System Setup
3. Select
Installation
4. Select
Caller ID
5. Select
Enable Caller ID
6. Select .
Done

Resetting Receiver to Factory Default Settings

: Resetting the receiver to factory default settings discards all
Note
except the
Lists All Chan
: If you have set any locks on the receiver, and the receiver is locked, these
Note
locks will be kept. If the receiver is unlocked, any such locks will be lost. You
cannot reset the receiver to default settings to discard a password you have
forgotten. Nobody can reset the receiver to bypass a receiver lock.
If you want to reset the receiver to be the same as when it was shipped from the
factory, do the following:
1. Press the MENU button.
2. Select the
System Setup
3. Select the
Factory Defaults
a message, confirm that you want to reset the
Warning
receiver's preferences by selecting
.
.
.
or select
Disable Caller ID
and lists.
All Sub
option.
option. When the receiver displays
Yes
Resetting Receiver to Factory Default Settings
.
.
Favorite
Page 101