Setting Up Tv1 To Operate In Uhf Pro - Dish Network Receiver User Manual

Setting Up TV1 to Operate in UHF Pro

You can set your receiver to operate your TV1 using another UHF Pro remote
control (sold separately) by completing the following instructions:
If you set up your receiver to operate the
the two UHF Pro remotes for this receiver will interfere with
each other when operated at the same time. This may prevent
the remotes from operating the receiver momentarily.
1. Perform the following using an existing remote control:
a. Open the
TV1 UHF Pro Setup
remote control.
b. Select
Enable
c. Select
System Info
d. Move the highlight to the address for the
shown below. This is important—if you do not do this, your remote will
change the receiver's
Remote Control 1 to control the
2. Perform the following using the UHF Pro remote that you are going to use
to control TV1:
a. Press and hold the SAT mode button for about three seconds, until all
the mode buttons light up, and then release the SAT button. The SAT
mode button will begin to blink.
b. Use the NUMBER PAD buttons to enter any number from 1 to 16,
except for the number shown by the
SAT mode button goes out after you enter each digit, and then lights up
again.
Write down the number you entered:
c. Press the POUND (#) button. If you entered the address correctly, the
SAT mode button will flash three times.
d. Press the RECORD button.
e. Make sure the
Remote Address
matches the number you entered in step 2b.
screen by pressing MENU-6-1-6 on the
from the
TV1 UHF Pro Setup
to open the
System Information
Secondary Remote Address
side of your receiver.
Secondary Remote Address
screen shows that the
System Information
shows
UHF Pro and IR
Setting Up TV1 to Operate in UHF Pro
side using UHF Pro,
screen.
screen.
Primary Remote Address
and cause your
Note: Highlight the
Primary Remote
Address.
Primary
and that this address
as
. The
Page 45