Testing The System; Telephone Connection Test - Dish Network Receiver User Manual

Chapter 3
Using the System

Testing the System

Starting a Test

Telephone Connection Test

Page 116
1. Press the MENU button.
2. Select the
System Setup
3. Select the
Diagnostics
This test checks that the receiver telephone connection is correct. Select the
option to begin the test. The receiver displays a message asking
Connection
you to wait until the test is done.
• If the telephone connection is correct, the receiver displays a
message.
Connection OK
• If the receiver highlights the
receiver can make a toll-free call to the Customer Service Center. Press the
remote control SELECT button to start the call. The receiver displays a
message asking you to wait until the call is done. When the call is done,
select the option to exit the test menu.
Done
• If the telephone line is not connected properly, the receiver displays a
failure message. In this case, check the telephone connection and then
repeat the test.
: If you have the receiver connected to a DSL (Digital Subscriber Line)
Note
phone line, it may cause this test to fail. If so, you will need to install a DSL
filter between the satellite receiver and the telephone jack on the wall. You
should be able to get a DSL filter from your DSL provider, or your local
consumer-electronic parts store.
option.
option.
option, select the
Done
Phone
option so the
Dial Out