Changing The Tv1 And Tv2 Output Channels - Dish Network Receiver User Manual

Chapter 2
Receiver Description and Installation
Programming the Recover Button Channel
Removing the Recover Button Channel Programming

Changing the TV1 and TV2 Output Channels

Page 36
1. Program Remote Control 2 to control your remote TV using the instructions
in Control Other Devices with the Remote Controls on page 104.
2. Press and hold the TV mode button until all the other mode buttons
light up, and then let go of the button. The TV mode button flashes.
3. Press the STAR (*) button.
4. Enter the three digits of your channel number. For example, if your
remote TV is set to channel 60, enter 0-6-0.
5. Press the POUND (#) button. The TV mode button flashes three
times.
The following instructions describe how to reset the RECOVER button to the
way it was delivered to you from the factory.
1. Press and hold the TV mode button until all the other mode buttons
light up, and then let go of the button. The TV mode button flashes.
2. Press the STAR (*) button.
3. Press 0-0-0.
4. Press the POUND (#) button. The TV mode button flashes three
times.
The receiver comes preset to use channel 3 for
. If you are experiencing interference on the channels you are using, follow
TV2
these instructions to change the channel that
Make sure you are familiar with how to change channels on
your TV, and if necessary, how to switch your TV between
off-air and cable channels. When you change these receiver
output channels, you must also change the channels on your
TV(s) to tune to these channels to watch the video from the
receiver. See your TV user guide for instructions.
and off-air channel 60 for
TV1
or uses.
TV1 TV2