Getting Started; System Info; Program Guide - Dish Network Receiver User Manual

Chapter 1
Introduction
Tip: In Dual Mode,
Remote Control 1
is used to control
TV1 menus on the
nearby TV. Remote
Control 2 is used to
control TV2 menus
on the remote
TV(s).
Page 6

Getting Started

After your system has been installed, order and watch your programming
using the following steps:
Step 1: Ordering Your Programming
1. Using a remote control, press SAT and then press the blank
POWER button to turn on the receiver. Make sure the TV is
also on.
2. Press GUIDE.
You will see that some channels in the
These channels can be viewed immediately. However, many channels
will be shown on a red background. You cannot view these channels
until you order programming.
3. Press the SYSTEM INFO button on the receiver front panel to display
the

System Info

: The following screen is an example only. Be sure to use the
Note
numbers on the
4. Call the Customer Service Center at 1-800-333-DISH (3474). A
customer service representative will help you start DISH Network
programming on your system and will discuss the various programming
packages available.
5. Choose a package and the representative will authorize your
programming.
6. Press SELECT to close the
7. Wait a few minutes and the channels you purchased will turn from red
to white backgrounds in the

Program Guide

screen.
screen displayed on your TV.
System Info
System Info
Model ID DISH Player-DVR 522
Receiver CA ID R00000000000-00
Smart Card ID S00000000000-00
DNASP000 Rev000
ABCDEFGH-I
Software Version Software Version
Boot StrapVersion 0000ABCD
Customer Service 1-800-333-DISH (3474)
Internet Address http://www.dishnetwork.com
Receiver Mode Dual Mode
Location ID 1111ABCD:0000A0B00
5 5
Primary Remote Address 1 IR
5
Secondary Remote Address 2 UHF Pro
Help
Done
Copywrite 2011, EchoStar Technologies Corp. All Rights Reserved.
System Info
Program Guide
appear in white.
1
Mon, October 18
2
Cancel
screen, if displayed.
, and can now be viewed.