Chapter 3
Using the System
Turning Caller ID On and Off
Resetting to Factory Default Settings
Page 70
1. Press MENU on the remote control.
2. Select
System Setup
3. Select
.
Installation
4. Select
.
Caller ID
5. Select
Enable Caller ID
6. Select
.
Done
: Resetting the receiver to factory default settings discards all
Note
except the
Lists
All Chan
: If you have set any locks on the receiver, and the receiver is locked,
Note
these locks will be kept. If the receiver is unlocked, any such locks will be
lost; however, you cannot reset the receiver to factory default settings to
bypass a lock or to discard a password you have forgotten. Call the Customer
Service Center if you have forgotten your password.
Complete the following instructions if you want to reset the receiver to be
the same as when it was shipped from the factory.
1. Press the MENU button.
2. Select the
System Setup
.
or select
Disable Caller ID
and
lists.
All Sub
option.
.
Favorite