Dish Network Receiver User Manual page 121

Removing SAT Auto-Tune Channel
1. Press and hold the TV Mode button until all four Mode buttosn are
lit.
2. Press STAR (*).
3. Enter 00 or 000.
4. Press POUND (#). TV flashes three times to indicate SAT Auto-
Tune has been removed.
Setting Auto-Tune for DVD/VCR
You can set Auto-Tune for your DVD and/or VCR. Auto-Tune allows
you to return to the channel for your DVD/VCR output when you
accidentally change the channel or video input.
Note: This feature is only used while recovering your picture. See
Recovering Your Picture on page "Recover Button" on page 55.
1. Make sure the remote control operates your DVD/VCR.
2. Press and hold DVD until all four Mode buttons are lit.
3. Press STAR (*).
4. Enter the channel used for viewing (two or three digits in range of
002 to 125), for example, channel "03" or "004".
5. Press POUND (#). the Mode button flashes three times to indicate
programming was successful.
Removing Auto-Tune for DVD/VCR
If you want to remove Auto-Tune for your DVD and/or VCR, follow
the steps below.
1. Press and hold DVD until all Mode buttons are lit.
2. Press STAR (*).
3. Enter 00 or 000.
4. Press POUND (#).
Control Other Devices with the Remote Controls
Page 115