Dish Network Receiver User Manual page 83

6. Press RECORD. Select one of the following:
• Select to start the recording now.
OK
• Select
Options
–
Stop Recording Manually
press STOP.
–
Extend End Time
–
Create a Recurring Timer
described in Setting Up an Automatic Event Timer.
–
Record the Entire Event
of the event. This selection is available only if the receiver was
tuned to the channel at the beginning of the program.
7. Press DVR on the remote control. The
should see the two programs that are recording indicated by the bright red
dot next to the listings.
8. Select a program that you recorded earlier (one that is not recording now),
then select or
Start
9. You should now be watching a pre-recorded program while the receiver is
recording the other two events (programs).
Watching One Program While Recording Another
to customize the following:
—The receiver will record until you
—You can set the stop time for the recording.
—You can set up a timer like the one
—The receiver stops recording at the end
DVR Event
.
Start Over
screen will open. You
Page 77