Cisco DPQ2425 User Manual page 27

5 Connect one end of a telephone jumper cable (not included) to a telephone outlet
in your home or to a telephone or fax machine. Then connect the other end of the
jumper cable to the appropriate RJ-11 TELEPHONE port on the back of the
gateway. The telephone ports are light gray and are labeled 1/2 and 2 or 1 and 2
depending on the region of the world the gateway is used.
Notes:
–
–
–
6 Locate the AC power adapter provided with your gateway. Insert the barrel
shaped DC power connector (attached by a thin pair of wires to the AC power
adapter) into the black POWER connector on the back of the residential gateway.
Then, plug the AC power cord into an AC outlet to power-up the gateway. The
residential gateway will perform an automatic search to locate and sign on to the
broadband data network. This process may take up 2-5 minutes. The modem will
be ready for use when the POWER, DS, US and ONLINE LEDs on the front panel
of the gateway stop blinking and remain ON continuously.
7 Plug in and power on your PC and other home network devices. The
ETHERNET LEDs on the gateway corresponding to the connected devices
should be ON or BLINKING.
8 Once the gateway is online, most Internet devices will have immediate Internet
access.
Note: If your PC does not have Internet access, refer to How Do I Configure
TCP/IP Protocol? (on page 104) for information on how to configure your PC for
Internet access. For Internet devices other than PCs, refer to the DHCP or IP
Address configuration section of the User Guide or Operations Manual for those
devices.
4028630 Rev A
Make sure to connect your telephone service to the correct RJ-11 port. For
single line telephone service, connect to port 1/2 or 1.
Gateways used in North America have multi-line capability on the RJ-11
telephone port labeled 1/2. Line 1 is on pins 3 and 4 of port 1/2, and
Line 2 is supported on pins 2 and 5. Gateways used in Europe support
only one line per port. Line 1 is on port 1 and line 2 is on port 2.
Telephones that require electrical connectors other than RJ-11 may
require an external adapter (sold separately).
How Do I Connect My Gateway for Internet and Telephone Service?
27