Cisco DPQ2425 User Manual page 66

How Do I Configure My Wireless Residential Gateway with Digital Voice Adapter?
Remote Endpoint Settings
These settings control how the local endpoint (router) connects to the far VPN
termination point (the other end of the VPN tunnel).
Field Name
Address group type
Subnet
Mask
Identity type
66
Description
Allows you to select the address group type for the remote VPN access
group. The following types are available:
IP subnet
Single IP address
IP address range
The remote VPN endpoint on the other end of the tunnel should match
these settings for its remote endpoint settings
Allows you to enter Subnet information based on the selected Address
group type as follows:
For IP subnet, enter the subnet
For single IP address, enter only the specific IP address
For IP address range, enter the starting and ending IP addresses
Allows you to enter Mask information based on the selected Address
group type as follows:
For IP subnet, enter the subnet mask
For single IP address, enter only the specific IP address in the
Subnet field. Leave this field blank.
For IP address range, enter the starting IP and ending IP addresses
Allows you to select the remote Identity type from one of the following
options:
WAN IP address of the router (default)
User-specified IP address
Fully qualified domain name (FQDN)
Email address
This is the identity that the far endpoint will use for identification of the
VPN termination point. The remote VPN endpoint on the other end of
the tunnel should match these settings for its remote endpoint settings
4028630 Rev A