Verifying Software Version; Copying Files To The S8300 - Avaya G700 Installation Manual

Arrange access to another hard drive (comcode 700307028) should it be necessary to
perform the TFTP remaster procedure on it.

Verifying software version

Note:
Since the system is now running a new software release, you must login with the
Note:
initial craft ID and password. (You cannot use dadmin at this point.)
To verify the software version
1. Log on to Integrated Management and launch the Maintenance Web Interface.
2. Under Server, click Software Version.
3. Verify that the media server is running Release 2.2 software.
The Report as: string should show R012x.01 at the beginning of the string. For example,
R012x.01.0.411.1.
Tip:
Normally, you would need to use the Make Upgrade Permanent function on the
Tip:
Web Interface at this point. However, this is not necessary for this upgrade
because there is no previous software version in the alternate partition.

Copying files to the S8300

During reformatting of the hard drive, a new directory, /var/home/ftp/pub, was created. For
release 2.0 and later, this pub directory will be used as the /var/home/ftp directory that was used
in previous releases.
You must copy the remaining required files to the pub directory on the S8300 hard drive. This
includes, but is not limited to:
the post-upgrade software update file
License file
Avaya authentication file (if needed)
New firmware files
Note:
If you are copying a license file or authentication file, be sure the /var/home/ftp/
Note:
pub directory contains no files with a *.pwd or *.lic extension. There should be
only one of each of these file types this directory. If any of these file types exist in
the pub directory, move, rename, or delete them before you copy the new files.
Upgrading the S8300A
Issue 7 January 2005 275