Note:
The LSP node names must be administered on the node-names-ip form before
Note:
they can be entered on the LSP form.
To add LSP names to the LSP screen
1. At the SAT prompt, type change lsp to open the LSP screen.
LSP Screen
change lsp
Number NAME
1
node-10-LSP_
2
____________
3
____________
4
____________
5
____________
6
____________
7
____________
8
____________
9
____________
10
____________
11
____________
12
____________
13
____________
14
____________
15
____________
16
____________
2. Enter the node name for each LSP supported by the primary controller.
3. Submit the form.
Administering the Media Gateway
To perform the procedures in this section, telnet to the primary controller, log in, and open a SAT
session.
!
CAUTION:
Before administering a media gateway, make sure that the gateway has been
CAUTION:
fully configured.
In this section, you will do the procedures:
LOCAL SURVIVABLE PROCESSOR
IP Address
192.168.1.50
out-of-service
out-of-service
out-of-service
out-of-service
out-of-service
out-of-service
out-of-service
out-of-service
out-of-service
out-of-service
out-of-service
out-of-service
out-of-service
out-of-service
out-of-service
Administer Communication Manager
Page
1 of
Service
Translations
State?
Updated
in-service
14:21 5/4/2003
Issue 7 January 2005
16
231