Upgrading an Existing S8300B to R2.x
Example: Show mg list_config
SLOT
TYPE
----
------ -----
V0
G700
V1
ICC
V2
DCP
V3
ANA
V4
DS1
Installing new firmware on the media modules
For upgrades of active media modules, you need to take the media modules out of service
before initiating the upgrade process. To do this, go to a SAT session on the primary controller
and issue a busyout command.
Note:
Skip this busyout procedure if the media modules are not in service; for example
Note:
during an initial installation.
To busyout board (for active media modules)
1. Go to a SAT session on the primary controller and enter the command,
busyout board vx
where x is the slot number of the media module to be upgraded.
2. Verify the response,
Command Successfully Completed
3. Repeat for each media module to be upgraded.
To install media module firmware
1. Be sure that you have checked for the current vintage of the VoIP Module for the v0 slot (on
the G700 motherboard).
This VoIP module does not occupy a physical position like other media modules.
2. At the P330-1(configure)# prompt, type session mgp.
3. At the MG-001-1(super)# prompt, type configure to change to the configuration mode.
4. Type copy tftp mm-image v<slot #> <filename mm>
<tftp_server_ip_address>
where
<slot #> is the slot of the specific media module,
<filename mm> the full-path name of the media module firmware file in a format such as
360 Installation and Upgrades for Avaya G700 Media Gateway and Avaya S8300 Media Server
CODE
SUFFIX
HW VINTAGE
------
----------
DAF1
A
00
S8300
A
72
MM712
A
2
MM711
A
2
MM710
A
1
FW VINTAGE
VOIP FW
----------
-------
230(A)
67
00
N/A
58
N/A
57
N/A
58
N/A