Registration; Registering A Handset In The Base Unit - Panasonic KX-TCD725EM Operating Instructions Manual

KX-TCD725EM-4(65~85)

Registration

Registering a Handset in the Base Unit

You must register the handset in the base unit before use.
Charge the optional handset batteries for approximately 15 hours before initial use.
Make sure that the power is ON (p. 12) and the unit is in the standby mode.
Register the handset number within 1 minute. If not registered within 1 minute, press
handset to cancel the programming mode. Then start over again from step 1.
1
Handset:
Press .
2
Press or
to "Setting Handset", then press
.
3
Base unit where handset is to be
registered :
Press and hold
for more than 10 seconds until a
confirmation tone sounds.
4
Handset:
Press or
to "Registration", then press
5
Press or
to "Register H/set", then press
.
The available base unit numbers are
displayed.
6
Press or
base unit number, then press
The number is assigned as the base unit
number for the handset.
P l e a s e W a i t . . .
80
01.7.19 10:23 PM Page 80
until the arrow points
on the base unit
until the arrow points
.
until the arrow points
to select the desired
.
7
Enter the 4-digit base unit PIN (p. 55).
E n t e r B a s e P I N
: -
8
Press .
"Please Wait..." is displayed, then
a confirmation tone sounds.
The handset will return to the standby
mode. The current connected base unit
number will be displayed.
B a s e 2
0 N e w C a l l s
To register the handset in more than one
base unit, repeat from step 1 with the
other base unit(s).
You can exit the programming mode any time
by pressing .
The base unit number which the handset is
currently in contact with can be displayed in
the standby mode (p. 46). Calls (both incoming
and outgoing) can be conducted only via the
displayed base unit (even if the radio areas
overlap with neighbouring base units).
on the