Specifying Settings From the Control Panel
To specify status notification settings
1
In the Administrator Setting screen, touch [5 Network Setting]. (Refer to
page 4-10 for more details.)
2
In the Network Setting screen, touch [0 Detail Setting].
3
In the Detail Setting screen, touch [3 Status Notification Setting].
–
To quit specifying the Utility mode setting, touch [Exit] in the sub
display area. Otherwise, cancel the Utility mode by touching [Close]
in each screen until the screen for the Copy, Fax, Scan or Box mode
appears.
–
Refer to "E-Mail TX (SMTP) Parameters" on page 4-81 for more
details.
The Status Notification Setting screen appears.
4
Specify the desired settings.
Reminder
To apply network setting changes, turn off the main power of the
machine, wait 10 seconds, and then turn the machine on again.
bizhub 500/420
4
4-101