Table of Contents
Advertisement
Getting to Know Your System
CAUTION
External influences can cause damage to the system!
External influences can cause damage to the system. Observe the
following safety precautions to prevent system damage.
➜
Do not subject the system to vibrations.
➜
Never bring any magnetized object near the system.
➜
Never place any objects heavier than 6.8 kg and/or thicker than 30 mm
onto the system.
➜
Do not put any objects under the main tray of the finisher. During the
output cycle, the finisher moves downward and can be damaged by
objects in its way.
CAUTION
Incorrect handling can cause damage to the system!
Incorrect handling can cause damage to the system. Observe the
following safety precautions to prevent system damage.
➜
Do not open any doors on the system during printing.
➜
Do not switch the system off during printing.
➜
Ensure that the finisher trays are not overloaded during copying. If
necessary, remove finished copies during the process to avoid
overloading the trays.
➜
Never use stapled, conductive, or heat-sensitive paper. Do not use
colour OHP transparencies.
CAUTION
A negligible amount of ozone is released during printing!
While this is not a health hazard, it may result in an unpleasant odor. It is
recommended that the room be well ventilated.
➜
Locate the system in a well-ventilated room.
Di551/Di650
2
2-19
Advertisement
Table of Contents
