Table of Contents
Advertisement
Basic Functions
Procedure
Activate tandem mode to run two systems in parallel operation.
1
Switch both systems on.
2
Wait until both systems are ready to copy.
3
Press the [OUTPUT MENU] key on the system that you want to run as
the master unit.
The finishing settings are shown.
4
Press the [TANDEM] key.
The background of the key turns black. This system is now the master
unit. The other system will now operate as the slave unit.
?
If the tandem mode cannot be activated
Tandem mode cannot be activated in the following situation:
➜
The slave unit has been switched off by the "auto shut off" function.
Switch the slave unit back on using the [ENERGY SAVER] key on
the control panel.
➜
An error has occurred on the slave unit, such as a paper misfeed
or paper has run out. Resolve the problem.
➜
Ten reserve copy jobs have been set up on the slave unit (not in
tandem mode). Wait until the reserve copy jobs have been
processed.
5
Make any necessary changes to the copy settings on the master unit.
Di551/Di650
4
4-39
Advertisement
Table of Contents
