3
Procedure
1
On the control panel press the
[INTERRUPT] key.
2
Wait until the LED on the
[INTERRUPT] key on the control
panel is lit (not blinking).
The interrupt is active.
3
Remove the originals of the interrupted copy job from the EDH or the
original glass.
4
Load the new originals
❍
into the EDH or
❍
on the original glass.
5
Make any necessary changes to the system settings.
❍
Copy Mode:
❍
EDH:
❍
AE:
❍
Magnification Ratio:
❍
Finisher:
?
What is displayed when check mode is opened?
➜
Check mode shows the settings of the interrupted copy job.
6
Press the [START] key on the control panel to start the copy job.
3-30
1-1
ON
ON
1,000 (100%)
main tray, sorted
Initial Steps . . .
Di551/Di650