Table of Contents
Advertisement
7
Setting
19
Staple mode reset-function
20
JOB offset operating
21
Continuation print
22
Key click sound
23
Indication time
24
Energy saver screen
25
Start key latch function
26
Stop key function
27
Auto select of Booklet copy Enabling the "Folding" or "Stapling &
28
E.K.C. password
29
Arrow key change Image
Shift
30
Exit direction of 1 sheet
* Initial setting
7-52
Settings in Key Operator Mode
Function
The "staple" function is reset when the copy
job completes:
OFF* / ON
More than one reserved copy jobs are
output with offset.
OFF* / ON
More than one reserved copy jobs are
output automatically in sequence.
OFF* / ON
Acoustic signal when a key on the touch
screen is pressed.
OFF* / ON
Time after which a new display appears.
3 seconds* / 5 seconds
The energy saving function will be enabled
when the [ENERGY SAVER] key on the
control panel is pressed:
Auto shut off mode* / Energy save mode
Auto copy start after warm-up time.
OFF* / ON
When the [STOP] key on the control panel is
pressed, the copy job is either canceled or
only interrupted.
JOB momentary stop* / JOB cancel
Folding" function enables the booklet
function:
Automatic selection* / Non Automatic
selection
Length of the E.K.C. password
8 digits* / under 8 digits
Interval for image shift
Decimal point OFF 1 step-1mm* / Decimal
point ON 1 step-0.1 mm
Single copies are output with:
Face down* / Face up
Di551/Di650
Advertisement
Table of Contents
