Enter Hip Communication Mode - Xerox DocuPrint 96 Operator's Manual

HIP PRINTING TASKS
HIP printing tasks

Enter HIP communication mode

Enter HIP Communication Mode task
7-2
You can perform HIP printing tasks by entering commands through
the keyboard.
The following sections contain instructions for performing specific
HIP printing tasks.
Use this task to enter HIP communication mode.
Enter the following command:
HIP [option[,option[,...]]]
HIP options are provided in this chapter in the task sections;
however, for a complete list and explanation of all available HIP
options, refer to the Xerox DocuPrint 96/DocuPrint 96MX LPS
Operations Reference .
Note the following:
•
If your LPS has only one host and it is set up as the default host
in HIP.LIB, or if only one host is set up in HIP.LIB, entering HIP
has the same effect as entering HIP HOST, HIP ONLINE, and
HIP START.
•
If your LPS has more than one host, then the one which is set
up as the default host in the HIP.LIB becomes active when you
enter the HIP command. If you want to use another host, you
must specify the host name.
•
The first time you enter HIP after performing a system
generation, you must specify a host name. This host is saved in
the recovery file of the system disk. If you do not enter a host
name, the following message appears:
HP2010 NO HOST SELECTED
•
If the host is not online and responding, the following message
appears every 15 seconds until the host comes online or HIP is
terminated:
HP1240 HOST NOT RESPONDING
Note: Note that listed options are separated by commas while
parameters are separated from the option keyword by a space.
XEROX DOCUPRINT 96/DOCUPRINT 96MX LPS OPERATOR GUIDE