Xerox DocuPrint 96 Operator's Manual page 237

Command errors
Select a communication mode
Select a Communication Mode task
XEROX DOCUPRINT 96/DOCUPRINT 96MX LPS OPERATOR GUIDE
If an error is detected in the command line, the incorrect part of the
line is displayed. A message to correct and reenter the command is
made as follows:
HP2300 COMMAND IN ERROR AT: (part of command in error)
HP2310 RE-ENTER COMMAND
Some commands are not valid for all hosts, and some commands are
not valid if a host is not selected. When this happens, one of the
following messages appears:
HP1320 FUNCTION IS NOT SUPPORTED BY CURRENT HOST
HP2320 INVALID COMMAND WITH CURRENT HOST TYPE
HP2330 INVALID COMMAND WITH NO HOST SPECIFIED
Use this task to select the HIP communication mode to use.
Note: This task is not necessary if your LPS has only one host.
Enter the following command:
HIP HOST {XNS | XPF}
HIP must be offline to change from one host to another. If the system
is not offline or is not idle, the command is rejected and one or more
of the following messages appears:
HP2020 SELECTED HOST NOT PRESENT ON SYSTEM
HP2400 HIP INTERFACE MUST BE OFFLINE. ENTER 'HIP
OFFLINE'.
HP7100 CANNOT CHANGE HOSTS WHILE JOBS ARE PENDING
OR ACTIVE.
HIP PRINTING TASKS
7-3