Maintaining The Printer; Replacing The Dry Ink Cartridge - Xerox DocuPrint 96 Operator's Manual

MAINTENANCE TASKS

Maintaining the printer

Replacing the dry ink cartridge

10-2
When supplies for the LPS need to be replaced, for instance, when
the dry ink supply is low, the following indications appear:
•
If enabled, the Attention light goes on.
•
A message and instructions appear on the printer control
console.
•
The Hint icon appears on the printer control console.
Note: If the Attention light is turned off, the Hint icon does not
appear.
To ensure that the LPS runs efficiently, replace the appropriate
supplies as soon as possible after seeing the indications. If you do
not do so, the printer eventually stops and does not continue until you
replace the supplies.
Note: Make sure to use only MICR dry ink. The dry ink cartridge of
the DocuPrint 96/DocuPrint 96MX system is red, and the dispenser
is keyed to prevent the installation of the wrong type of dry ink.
Follow this procedure to replace the dry ink cartridge:
Step 1. Open the printer's right and left doors and locate the dry ink area at
the left side of the printer (see figure 10-1). There are step-by-step
instructions on the panel next to the dry ink cartridge.
Figure 10-1. Locating the dry ink cartridge
Step 2. Place a drop cloth on the floor under the dry ink area.
Step 3. Pull the empty dry ink cartridge out until it stops.
XEROX DOCUPRINT 96/DOCUPRINT 96MX LPS OPERATOR GUIDE