MAINTENANCE TASKS
10-8
Step 4.
Locate the fuser agent reservoir (see figure 10-11).
Figure 10-11.Locating the fuser agent reservoir
Step 5.
Pull the fuser agent reservoir out until it stops.
Step 6.
Remove the reservoir cap by turning it counterclockwise.
Step 7.
Remove the cap from a new bottle of fuser agent.
Warning: If any fuser agent spills on the floor, remove it
!
immediately. Fuser agent spills make the floor slippery.
Caution: The fuser reservoir has an antisplash seal. Do not
push the fuser agent bottle into the reservoir with excessive
force, as this can damage the seal.
XEROX DOCUPRINT 96/DOCUPRINT 96MX LPS OPERATOR GUIDE