Xerox DocuPrint 96 Operator's Manual page 129

XEROX DOCUPRINT 96/DOCUPRINT 96MX LPS OPERATOR GUIDE
Step 4. Press <Y> if they are correct.
If either is incorrect, enter <N> and reenter the date and time
correctly.
Note: You are not always asked to enter the date and time.
Step 5. You are asked if you want the time displayed in the upper right corner
of the screen and a constant update of the system's status.
LOAD AND ENABLE TIME-OF-DAY/STATUS DISPLAY (Y/N)?
In most cases, you should press <Y> for yes. If you do so, the system
keeps you informed of the time and status. If you want to disable this
feature at a later time, enter TIME OFF. To reenable it, you need only
enter TIME ON.
If <N> is entered, you cannot add the time/status display without
rebooting the system.
Allow four to seven minutes for the printer to complete its warm-up.
When the printer is ready, a tone sounds, and the following message
appears:
READY---JOB START WILL BE DELAYED 40-80 SECONDS FOR
PRINT QUALITY ADJUSTMENT
Note: Before the LPS starts printing, the system checks print
quality and controls. Any adjustments, if necessary, are made by
the system to give you the best quality prints. The system also
checks print quality on an ongoing basis and may stop printing,
correct a quality problem, and resume where it left off.
SYSTEM CONTROL TASKS
3-5