Xerox DocuPrint 96 Operator's Manual page 57

XEROX DOCUPRINT 96/DOCUPRINT 96MX LPS OPERATOR GUIDE
SYSTEM OVERVIEW OF THE XEROX DOCUPRINT 96/DOCUPRINT 96MX LPS
Each processor feeder tray and HCF tray has a control panel
consisting of a button, indicators, and paper level displays, as shown
in figure 1-7.
Figure 1-7. Feeder tray control panel
1 Ready to Open indicator
2 Please Wait indicator
3 Tray Unlock button
4 Paper Level indicators
Ready to Open indicator. This indicator is lit when paper can be
added to the tray.
Please Wait indicator. This indicator shows that the tray is in
motion. It is lit when the Tray Unlock button is pressed, when the tray
is being lowered, or when the tray is being raised. The indicator goes
off when the tray elevator reaches its destination.
Tray Unlock button. This button can be used any time the Please
Wait indicator is off.
•
If the tray is in use when this button is pressed, the feed
selection changes to the backup tray if one exists. Otherwise,
printing stops.
•
If the tray is in use and selected as a backup tray, pressing this
button causes the tray elevator to lower and the tray is no
longer available for auto switching.
•
If the tray elevator is in the raised position and the tray is not in
use or selected as a backup tray, pressing this button causes
the elevator to lower with no effect on printing operations.
Paper Level indicators. These indicators display the approximate
quantity of paper within the tray. The display shows paper by quarter
reams up to one ream, and then by full reams. The green indicator
light appears above the Paper Level indicator which shows the
amount of paper in the tray.
1-7