Y119-Enable/Disable Automatic Paper Size Configuration; Y120-Setting Printout At Power Up; Y249-Enter Engineering Mode - Xerox 4215 Reference Manual

FUNCTION SELECTION VIA LINE (FSL) COMMANDS
Y119—Enable/disable automatic paper size configuration
Y120—Setting Printout at Power Up
Y249—Enter Engineering Mode
3-64
@Y119, n@
Enables or disables Automatic Papersize Configuration logic.
n
Remember: Do not disable Automatic Papersize Configuration if you have the
IPDS option installed.
Example @Y119, 2@ enables Automatic Papersize Configuration logic.
@Y120, n1@
Prints out the current settings when the printer is powered up.
n1
Refer also to FSL commands T2—Online Hex Dump, and T4—
Printout Settings that print out current settings on your printer.
Refer also to FSL commands T2—Online Hex Dump, and T4—
Printout Settings that print out current settings on your printer.
@Y249, n@
Enables the rest of the engineering functions and FSL setup using
Centronic/RS 232 input.
n
The engineering switch function will be enabled after receiving
the password using this FSL Y249 command.
Remember This is strictly an engineering function.
The valid values are:
0 Disables the Automatic Papersize
Configuration logic.
1 Reserved for future use
2 Enables the Automatic Papersize
Configuration logic.
The valid values are:
0 No printout requested
1* Printout requested
Represents the password FOREST.
XEROX MRP FAMILY COAX COMMAND REFERENCE