Bin full criteria and setting bin limits
Bin Full Criteria and Setting Bin Limits
XEROX DOCUPRINT 96/DOCUPRINT 96MX LPS OPERATOR GUIDE
You can request that bins continue to fill until:
•
A specific number of reams or sheets has been stacked
•
A specific report, report set, or print job is finished
•
A specific report, report set, or print job is finished after a
specific number of sheets has been stacked.
To set the maximum number of reams for the bin, enter the following
task
command:
BINFULL [ threshold, boundary ]
Table 8-9 lists each parameter and its description.
Table 8-9.
BINFULL command parameters and descriptions
Parameter
threshold
boundary
To specify the maximum number of sheets for the bin, enter the
following command:
BLIMIT bin letter,sheet count
Table 8-10 lists each parameter and its description.
Table 8-10. BLIMIT command parameters and descriptions
Parameter
bin letter
sheet count
Description
The maximum number of reams for the bin. This
number must be between 0 and 5.
Note: If the threshold is 0, the boundary must be
specified.
The separation boundary for the bin. The options
are:
•
NONE. There is no separation boundary.
•
SET. The stacking switches after each
printed set.
•
REPORT. The stacking switches after each
printed report.
•
JOB. The stacking switches after each
printed job.
Description
The bin whose limit you are setting. For example,
enter A to set the limit for stacker bin A.
The number of sheets that can be sent to the bin.
The number must be between 100 and 2500.
STATUS AND PRINT TASKS
8-13