Verifying that Self-Test Passed
To verify that the unit passed its self-test, go to the System and Test Status screen.
Main Menu → Status → System and Test Status
The results of the self-test appear directly under the screen title.
If any failure messages appear, reset the unit by disconnecting, then reconnecting the
power cord. The unit will perform the self-test again. If the failure reappears, call your
service representative for assistance.
Using the Easy Install Screen
An Easy Install screen is provided for custom configurations, but is not required for
normal installation. You can configure the router by making selections from the
Configuration Edit/Display menu.
Procedure
1. Select the Easy Install feature.
Main Menu → Easy Install
Easy Install Screen Example
main/easy_install
Device Name: Node A
-----------------------------------------------------------------------------
Ctrl-a to access these functions, ESC for previous menu
Save
DSLAM Type:
Node IP Address:
Node Subnet Mask:
TS Access: VPI,VCI
Create a Dedicated Network Management Link
Ethernet Management Options Screen
Network 1 DSL Line Rate (Kbps)
Network 1 FRF.8 Encapsulation Mod
EASY INSTALL
15
2/26/2001 00:01
Paradyne
000.000.000.000
000.000.000.000
0,35
AutoRate
Transparent
MainMenu
9783-C-SLV
Clear
Clear
Exit