Removing An Optical Drive - HP Pro 2110 Small Form Factor Maintenance & Service Manual

Removing an Optical Drive

CAUTION:
computer.
To remove an optical drive:
1. Prepare the computer for disassembly
2. Remove the access panel
3. Remove the front bezel
4. Disconnect the power cable (1) and data cable (2) from the rear of the optical drive.
Figure 5-21
5.
Pull out the drive latch and swing it to the left(1), then slide the drive out of the front of the chassis
(2).
Figure 5-22
Reverse the removal procedure to install an optical drive.
If installing a new optical drive in a previously unused drive bay, first remove the break-away EMF
shield from the front of the PC.
68 Chapter 5 Removal and Replacement Procedures Minitower (MT) Chassis
All removable media should be taken out of a drive before removing the drive from the
(Access Panel on page
(Front Bezel on page
Disconnecting the Power and Data Cables
Removing the Optical Drive
(Preparation for Disassembly on page
43).
44).
42).