Computer Setup-Power - HP Pro 2110 Small Form Factor Maintenance & Service Manual

Table 2-4 Computer Setup—Boot (continued)
Option
F12 Boot from LAN
Prompt
Hard Disk Boot Seq.
Optical Drive Boot
Seq.
Network Boot Seq.
First Boot Device
Second Boot Device
Third Boot Device
Fourth Boot Device
Set Supervisor
Password
BIOS Write
Protection
Computer Setup—Power
NOTE: Support for specific Computer Setup options may vary depending on the hardware
configuration.
Table 2-5 Computer Setup—Power
Option
After AC Power Loss
Wake on PCI Device
from S5
RTC Alarm Resume
Description
Disables/enables the F12 Boot from LAN prompt message on the logo screen.
Allows you to specify the order of attached hard drive devices (such as USB HDD storage or USB
flash media). The first drive in the order has priority in the boot sequence and is recognized as
drive C (if any devices are attached).
Allows you to specify the order in which attached optical drives (including USB ODD) are checked
for a bootable operating system image.
Allows you to specify the order in which network devices (including UP NIC cards) are checked for
a bootable operating system image.
Allows you to specify which devices will boot first, second, third, and fourth or to disable any of the
four:
Removable
●
CDROM
●
Hard Disk
●
Network
●
NOTE: MS-DOS drive lettering assignments may not apply after a non-MS-DOS operating system
has started.
Allows you to establish a password to control access to Computer Setup.
Disables/enables BIOS upgrading.
Description
Allows you to select system power loss behavior:
Off
●
● On
Last State
●
Disables/enables waking up from S5 by PCI device.
Disables/enables RTC (real-time clock) alarm.
HP Pro 2110 – Computer Setup (F10) Utilities 9