Installing Additional Drives - HP Pro 2110 Small Form Factor Maintenance & Service Manual

Installing Additional Drives

When installing additional drives, follow these guidelines:
The primary Serial ATA (SATA) hard drive must be connected to the dark blue primary SATA
●
connector on the system board.
Connect the first SATA optical drive to the white SATA connector on the system board.
●
● Always populate the dark blue and white connectors before the light blue and orange connectors.
The system does not support Parallel ATA (PATA) optical drives or PATA hard drives.
●
CAUTION:
If you are inserting or removing a drive, shut down the operating system properly, turn off the
computer, and unplug the power cord. Do not remove a drive while the computer is on or in standby
mode.
Before handling a drive, ensure that you are discharged of static electricity. While handling a drive,
avoid touching the connector.
Handle a drive carefully; do not drop it.
Do not use excessive force when inserting a drive.
Avoid exposing a hard drive to liquids, temperature extremes, or products that have magnetic fields
such as monitors or speakers.
If a drive must be mailed, place the drive in a bubble-pack mailer or other protective packaging and
label the package "Fragile: Handle With Care."
64 Chapter 5 Removal and Replacement Procedures Minitower (MT) Chassis
To prevent loss of work and damage to the computer or drive: