Table of Contents
Advertisement
Removing a slim optical drive
CAUTION:
computer.
1.
Remove/disengage any security devices that prohibit opening the computer.
2.
Remove all removable media, such as compact discs or USB flash drives, from the computer.
3.
Turn off the computer properly through the operating system, then turn off any external devices.
4.
Disconnect the power cord from the power outlet and disconnect any external devices.
CAUTION:
as long as the system is plugged into an active AC outlet. You must disconnect the power cord
to avoid damage to the internal components of the computer.
5.
If the computer is on a stand, remove the computer from the stand.
6.
Remove the computer access panel.
7.
Disconnect the power cable (1) and data cable (2) from the rear of the optical drive, push the
green release latch on the right rear side of the drive toward the center of the drive (3), then slide
the drive forward and out of the bay through the front bezel (4).
CAUTION:
avoid damaging the cable.
30
Chapter 2 Hardware upgrades
All removable media should be taken out of a drive before removing the drive from the
Regardless of the power-on state, voltage is always present on the system board
When removing the cables, pull the tab or connector instead of the cable itself to
Advertisement
Table of Contents
